How to fill keg's for strong man training 

I was stumped as to how to REassemble the keg, but simply snapping off that extra bit really did the trick! Cheers!

Thanks for the info ...way better than any of the written descriptions of how to remove the valve/spear I found!

Thanks AmusingYeti, yes they are a brutal piece of training equipment, best of luck with the shouldering.

i have two 30 liter kegs , i pushed in the rubber to let the air out . now the pressure is out , i,m drilling holes al ouround the center piece to get it complete out. I,m gona use it to make moonshine. i take a piece of wood and hammer it in the hole then dril a hole in it that fits the copper pipe that colekts the alcohol gas .

Once the centre piece drops you should be able to screw out the outer piece as the assembly should now be apart. Other than that I wouldn’t know.

Finally, a helpful video.

I've got 2 for the same purpose. Haven't got a clue how I'm gonna convert em yet. Have you tried your idea out yet?

I ended up depressing gas out and puncturing keg with a bricked hammer sharp bit then drilled hole bigger n. hammered a wooden grommet in it worked a treat grommet comes out with pliers doesn't leak

Thanks, I also have Kegs with the Circlip which is a lot easier to remove.

post a video of it id like to see as i have the same idea

I was stumped as to how to disassemble the keg. Thanks.

why not just get the connector from the bar and de-gas the keg then fill it through the top? that's how bar staff pour back into kegs! simple.it is also a one way valve so no water loss when filled and totally safe. stop risking serious injury when the job can be done 100% safe? Grundy connectors available on e-bay or your local barman will lend you one!

My best friend just got 30 stitches in his face and could have bled to death if no one was there to help him from not degassing the keg properly before removing the spear . To make it worse he runs nitrogen (beer gas) which is much a higher PSI. PLEASE PLEASE PLEASE bleed off all pressure before removing the spear. I have done it many times and it can be done safely.

why not just get the connector from the bar and de-gas the keg then fill it through the top? that's how bar staff pour back into kegs! simple.

ha I know not best way like your correct way

There's a warning on the side Bob. Should your friend be messing around with pressurized tanks? If someone else was there to help him sort his face out they should have advised him to leave it alone. I have a friends like yours and I wouldn't even trust them with a hammer

Hi Sevenhunter728, Check out the video response hope that helps.

That’s definitely a different way to do it.

Poor guy gotno shoe