Your content is top notch, thank you. Pipe invert elevation is the lowest point of the inside diameter. Pipe invert elevation is the elevation of the inside bottom of the pipe. You can see the value listed @6:25 under Constraints parameters. Lower End Invert Elevation = (-3.064).
Great video. Nice catch on the grease waste slope. One question, though. On the invert out, it was -10.69’, but the spot elevation gave it as 90.32’. Shouldn’t the actual elevation have been 89.31’? I think the spot elevation was grabbing the wrong data. At least I think it was.
Honestly, I think it might have been grabbing the wrong piece of data. There are two similar invert parameters, and I do think I might have been using the wrong one. I think I noticed it later on and made sure to fix it but I decided it was not that big of a deal. But glad you are paying attention haha! I have a little mini course where I explain how I built these tags available on my website.