Question, I have both the 28A and 28H. The volume pot was bad on the 28A. I found a replacement in a donor radio, IC-38A. The light in the display isn't working. The display works, just no light. I'm going to investigate the possibility of putting the complete front assembly from the 38 into the 28. Any thoughts?
The 38A model is different from 28A..if your problem only the back light,change the light bulb only,you can replace it with led light just put resistor if you don't have one.
@@rexdayanan5564 Thanks, I will give that a try. Correction on my earlier work. I replaced the squelch in the H with parts from the 38A. I replaced the volume pot in the A with one from an IC-1200.
You have to reset to remove all channel by pressing the reset switch located at the Rx board.. if you can see a small hole thats the switch,you just poke with a pin.