How To Fix Your Bows Tiller And What Tiller Is In Recurve Archery 

Very concise and easy to understand explanation of tiller, thank you.

Oh man, this helped out a ton. My bow (a gillo g2 with l2's) was loud. I checked the measurements like you did, realized I was half an inch off, made the change and now I could probably assassinate a ninja, its quiet.

Hi man. Good tutorial, just something you could mention is that by changing tiller you should re-measure the brace height and the position of the nocksets, as the arrow angle may change and probably hits the rest when leaving the bow, or affects the angle of their impact on the target. Thank you for the tutorial, keep going.

exactly what i was looking for. Thank you!

You sir are a very funny man. I enjoy your vids but this one was especially full of wit. Thanks

Hi. I have changed to shoot barebow so I now put 3 fingers under the nock instead of two below and one above. Now my bow groans when I shoot it like the limb doesn't like me coming down the string. I feel I need to adjust the tiller so I'm sharing the load to both limbs instead of the bottom limb so much. Is this right? If so what do I do?

On my ilf limbs wen I clicked them in they don't go fully over the tiller bolt wen strung only half the bolt holds it in place is this right or should it go in all the way in so the full bolt covers the limbs

I know this is an old post but can you help me understand the tiller on a recurve bow non removable limbs? I have a Hoyt Pro Medallist hunter 1973. Thank you Dan

If i'm using three under techniques, it is better to using positive or negative tiller?

When you measure the tiller, press the bow square against the limb and rotate the end looking for the smallest measurement. This should be 90°. But good video explaining tiller and how to adjust.

Split finger verse 3 under makes a difference regarding tiller...according to Hoyt,

I have krossan xenia 68" riser 25" I would like to know how to adjust the limbs trill please

Hi i'm traditional archer but i have question i'm advanced in archer, i'm pulling my bow without big difficulty i can hold him quite long but my left arm is shaking this don't disturb but this is weird ODPOWIEDZ

Hi Adjusting the limbs trill while the string set or loose

My bow has the same tiller length how to adjust it I have a wooden riser.

Haha I like you, you have a little resamblance to watsky

Hi I want to ask please I have loud cranck noise when shooting

😮😮😮😮😮👍👍👍👍

please help me . . . . . . . . . "assume" One uses 2-under, 1-above DRAW with a Finger-Tab. Assume One always re-adjusts String's Nok-set to same position on string r.w.t. Rest (for Nocking Arrow to string, same way). Assume default TILLER was set to Bottom-limb=7.0625" & Top-limb=7.375". . . . . . . . . . Now please help with what happens NEXT ..... if TILLER is CHANGED to Bottom-limb=6.875" & Top-limb=8.000" , will the Arrow arrive on the target higher up the face, or lower down on the face???? Also, if TILLER is CHANGED to Bottom-limb=7.5" & Top-limb=7.125" , will the Arrow arrive on the target opposite way to first [changing to EXTREME positive tiller] example {using the slight/minor Negative tiller}???? What does practical science demonstrate happens to arrow trajectory ???? Please help me ? ?

No, we cannot see the numbers.

Secound?

Good but too much talking