Been installing and a tech for 20 years plus . Good vid well explained and will help a lot of guys . Done a lot of the swing to slider conversions and pretty much like you do .
you are a God sent my man. i watch all your videos . i cannot tell you how much i have learnt and continue to learn from your channel . THANK YOU THANK YOU THANK YOU , so very much ,
Dankie dat jy die tyd gevat het om die hele installeering op te neem, verduidelik en op youTube te sit. Ek sal defnitief hierdie gebruik om my installeering te doen. Op die internet het al geleer om nie te kritiseer nie, omdat mense die werk GEDOEN het. En baie goed wat ek al gekyk het sal ek nooit aan pak nie. Maar ek wil net graag die volgende sê:" As n Boilermaker/fabricator, wanneer ek na die sweis werk skrik ek. Ek hoop dat jy by nou al baie beter kan sweis met n Arc Welder. n Arc Welder is self nie een van my sterk punte nie. Maar n enkel fase MIG Welder (hier by ons nouem hule dit inkorrek n "CO2 welder". Weet nie hoekom nie, want CO2 gasse word nie gebruik nie. Maar in elk geval.....) sal jou kwaliteit werk net soveel beter maak" Soos ek sê, ek kritiseer nie, dit is maar net n opinie. Weereens dankie vir die video.
Been uneasy advertising the Smart to my clients, been happy with Evo as I install it in three hours all by myself. But your explicit demonstration has boosted my confidence and would like to thank you. Just another question, been using lip channel instead of angle iron for railing, which one is the strongest?
According to the manual (www.centsys.co.za/pdf/PROD/SMART/Centurion%20Systems%20D5-Smart%20installation%20manual.pdf) ... 7.2. Retro-fit Installations (existing sites) The D5 SMART has been designed to retro-fit into most existing D3, D5 or D5-Evo installations, with the following provisions; * If the unit is installed with the gate in the closed position and the unit on the left-hand side (from the inside of the property), the rack should extend at least 75mm past the centre line of the existing pinion * If the existing unit is mounted with the maximum clearance to the foundation plate, the new unit will require that the rack be re-adjusted to obtain the correct mesh between the rack and pinion, as the existing bolts will be too short If the existing foundation plate is in a good condition, it is not necessary to replace it with the D5 SMART Foundation Plate. ****** However, ****** if the existing foundation plate is corroded or needs to be replaced for whatever reason, the D5 SMART foundation plate can accommodate the existing footprint without the need to re-route cable conduits.
