How To Install a NEW USB wall Outlet Easy  

Link to USB outlet on Amazon:
linktw.in/RLQqdo
For more great content check out our other platforms: linktr.ee/TheH...
How To Install a NEW USB wall Outlet Easy #diy
Replacing a standard electrical outlet with a receptacle that includes USB ports is a relatively straightforward process, but it requires careful attention to safety and adherence to local electrical codes. Here's a step-by-step guide to help you through the process:
Disclaimer: This information is intended for general guidance. Electrical work can be dangerous, and it is advisable to consult with a qualified electrician or your local building department if you are unsure or uncomfortable with the process. Always turn off the power at the circuit breaker before working on any electrical installation.
Materials and Tools Needed:
New standard outlet with USB ports.
Screwdriver (Phillips and flat-head).
Voltage tester.
Wire stripper.
Needle-nose pliers.
Wire nuts.
Electrical tape.
Circuit tester.
Steps:
1. Turn Off Power:
Go to your circuit breaker box and turn off the power to the outlet you'll be working on. Use a voltage tester to ensure that the power is indeed off.
2. Remove the Old Outlet:
Unscrew the cover plate and remove it.
Unscrew the screws holding the outlet to the electrical box.
Carefully pull the outlet out of the box, exposing the wires.
3. Take Note of Wiring:
Take note of how the existing outlet is wired. There should be two or three wires connected to the outlet:
Black (hot) wire: Connects to the brass or gold screw.
White (neutral) wire: Connects to the silver screw.
Green or bare (ground) wire: Connects to the green screw or a grounding terminal.
4. Disconnect Wires:
Loosen the screws holding the wires in place and disconnect them. If the wires are connected using stab-in connections, use a small flat-head screwdriver to release them.
5. Prepare the New Outlet:
If the new outlet has USB ports, it may have additional wires. Follow the manufacturer's instructions to connect these wires properly.
6. Connect Wires to the New Outlet:
Connect the black wire to the brass or gold screw.
Connect the white wire to the silver screw.
Connect the green or bare wire to the green screw or grounding terminal.
7. Secure the Outlet:
Gently push the outlet back into the electrical box.
Secure the outlet by tightening the screws.
8. Test the Outlet:
Turn the power back on at the circuit breaker.
Use a circuit tester to ensure that the wires are properly connected and that there is power to the outlet.
9. Secure and Test USB Ports:
Secure any USB wiring according to the manufacturer's instructions.
Test the USB ports with a compatible device to ensure they are functioning correctly.
10. Reinstall Cover Plate:
Once you're sure everything is working correctly, reinstall the cover plate.
Additional Tips:
Follow local electrical codes and regulations.
If you're uncertain about any part of the process, consult with a qualified electrician.
Ensure a tight connection of wires to avoid overheating.
Use wire nuts and electrical tape to secure wire connections.
Remember, electrical work should be taken seriously to prevent accidents and ensure the safety of your home. If you are uncomfortable or unfamiliar with electrical work, it's always best to seek professional help.
"As an Amazon associates' member, we may earn commissions on qualifying purchases"