How To Install A SAAS Pillar Pod With Gauges! 

Esperance for the win :)

My power wire (2015 MN) was in the same place but it was Red & Black. You can tap into the light wire in the lower dash panel just above the power socket/Cigarette lighter for illumination. It only works when you switch on the lights. There are a couple of good earth points, one is the fuse rack bolt on the left side of the fuse rack & there is another just below the right hand pillar & behind the kick pannel (it's the easiest- just a 10mil bolt.

Thanks for sharing, I was just looking to add that same (Nissan) SAAS pillar pod to my car so very helpful to see how it looks. Also, I was wondering where I was going to get into the ign wire - remove shroud and go from switch! Cheers mate.

Good ‘how too video’. You say “obviously” heaps!

Hi, I have a problem with my boosts gauge, it rising really slow when I step on the gas. I followed every procedure like u did on this video 😞

Your Vid is well explained,think im going to add a gauge like that to my L200. Whereabouts you live looks nice ?

What colour wire is the lights for the numbers just hooked up mine and the numbers don't light up

Is this a TD Triton? When getting boost gauge for a diesel does it have to be a certain one?

Hey mate. I Teed into my vacuum line on my 2016 Dmax and my needle actually goes backwards. What did I do wrong? I have the SAAS 20 psi diesel boost gauge.

G’day mate, where did you connect you positive and negative wires to? Straight to your battery or did you tap into something in your dash ?

Only thing is the elec tape round the heatshrink 😂 but everyone does things differently, you could’ve gone a bigger piece of shrink around all the connections you soldered up and covered for neatness

Bloody brillent when installing my own, made it easy. Now i have got to install a snorkel in my mn. Lol hit me up if you want to do it cause i sure as shit have never do it lol. On the serious note i need to get to the blanks to put the switch in for my spotties and the plastic isnt coming off. Any tips?

Hi, good video, where did you get your dash carpet from? Joe

Hey mate where about did you put the oil pressure gauge bolt?

Hey mate did you have a boost controller?

Nice why not show where the illumination wire is

Does this work if you have srs air bags in

hey mate, I fitted the same saas boost gauge today. It only is reading 5 psi at 2000rpm when sitting in the garage. would there be any difference if I was to actually drive the car? it just doesn’t seem right to me. the reason why i’m asking would the reading be different is because I can’t test drive the car at the moment as it’s in bits and I need to put half the car back together haha!

Love your videos brudda i dont own a triton but enjoy your videos i own an nm 3.2 turbo deisel pajero 👍

Ordered the same SAAS pillar mount today. Keen to Chuck it in the ute. Boost gauge & Volts to monitor the duel battery setup 🤘

What glue did u use?

thanks for sharing just wondering where about's diid you put the vacuum hose?

Where’d u get the pillar mount from?

would this gauge work well on a D4D 3.0L Toyota Hilux?

Looking forward to the battery setup, cheers.

Thx mate

You said “obviously” 48 times.

is the column universal fit? or is there different columns for differnt cars from SAAS?

How come the boost needle appears really jumpy? Is it that bad in real life or does the video just make it look that way? Cheers