Congrats on getting the car! It's a blast to drive :) And I appreciate it! I'll be trying to post eventually here, content is difficult with lack of space (hopefully changing soon).
:o I've been exposed. At the end you can hear the intake sound, but the exhaust only a little, yeah. Will do a proper side by side when I get that downpipe in!
@@MrJoe1627 nah I realized. By the end it was dark so filming it wasn't possible. Instead, I opted to show what it sounds like in the cabin of the car cuz you can't hear the turbo spool when at a standstill.
If you’re willing to dish out some $$ the M performance exhaust isn’t terrible. Adds a little. For full effect, you can dish out $$$$ for a full catback exhaust from any number of reputable dealers. Depends on your preference. Check videos out online for sound clips!
Yeahhhhhh it’s an M340i Ikon Motorsports lip. They don’t really make any for ours 😭 I had to do some janky taping and drilled two holes into my bumper with drywall screws. It ended up breaking and so it’s gone now. BUT I’m currently designing a front lip for the 330i G20s. Stay subscribed (or follow my Instagram @kamesociety) to stay updated with that 🙏🏽 Good luck with your search otherwise!
I think I got this one off Amazon. I just fitted an M340i lip to this one. Didn't work too well and broke off eventually. Then I got a proper fitting one off of ebay! There's a lot more support for 330i sport line bumpers online now.
It was pretty fiddly, but I was able to use a flathead to pinch the connector to pull it off (that's where the vid gets blurry). It's a lot of patience and trial and error. Best of luck!
I got the intake installed but my CEL won’t turn off. I have confirmed that everything including the MAF is seated properly but the code “air mass to low” keeps getting thrown
I attempted to do this today and got stuck oon trying to take out the turbo inlet clip and ended up putting the stock everything back on 🥲, any tips for the next attempt will be appreciated
That clip was a pain. I'd say keep trying if you really want the install to go. It took me about 20-30 minutes to get my inlet clip out and I used pliers and a butter knife. Tbh I never even thought to check if there was a tool or anything to make it easier, so there may be something out there