How to install PVC Bathroom Wall Panels 

If you have plasterboard that has not been skimmed, just use PVA, mix pva with water, brush it onto the board.

Most of these boards are 5mm

Yes

That’s why you measure, we had height differences that went into a slant from corner to corner, that was a real pain

PVC.

No. We are busy!

No because you will use trims for the ends on the panels so it's water tight

As instructed in the video, apply silicone sealer to the TnG joint of each panel.

​@@Parkertannerzi did this, then found out it was me

PVC cladding panels come in different sizes, mine were 8’x4’ and easier to work with, only needed 3 and shorten height on them.

The pannels are tongue and groove and the bead runs round the side but don't bother measuring the bead just scribe it off the aqua panel that you have cut ready to put in and your adhesive should be put on like dot and dap and don't bother putting the nozzle on your adhesive as you need it to come out in big blobs once every 150 mm across and down doesn't have to be a exact and avoid putting the adhesive near the edge as it will squirt out around the edge of the panel but do put the nozzle on the silicone and do a bed of silicone were your gonna place the qua panel which will give you your added protection but make sure you wipe off clear any smudges of silicone/adhesive that get on your board showertray/bath because you want to put a neat bead of silicone on after the install is complete I install these all the time so any questions just ask

Yes

Of course, that would be even better probably.

If you fit over existing tiles surely the end trim will sit off the wall by the depth of the old tile and look weird.

is that what its for? I was wdnering about that

Ha ha! I agree with you.