Eyyy !! Hello Welcome to Avila's Technology, in this video we are going to make a Tesla Coil !!!. Which I will improve in the future.
It is also worth mentioning that Avila's Technology is a channel for Science, Technology, Inventions, Tests, Experiments, Engineering, etc. (in case you have any suggestions, put them in the comments :) ....)
By the way, become a member of Avila's Technology and together let's grow this channel !!
MATERIALS
-Copper Wire or Magnet Wire of 0.5mm or 0.8mm (5m to 10m)
-It had PVC 15cm long and 2cm in diameter
-1 Single Switch
-1 33K Ohms or 22K Ohms resistor
-1 Transistor 2N2222A or a Tip31C
-A Piece of Wire Thicker than Magneto Wire
-LEDS (Optional)
NOTE
If it does not work for you the first time, do not despair, since it is something normal. Try to comply with the following conditions:
-The Primary and Secondary Coil Rotate in the same direction.
-The Secondary Coil Has 6 to 8 Turns.
-The Primary Coil Does Not Have As Many Spaces Between Turns.
-The Secondary Coil Has a Good Gap with the Primary.
-Try to Remove the Enamel from the Magneto Wire at the Start and End Tips.
-Check Continuity in the Wire since then they come defective.
Remember to take your precautions, since the Tesla Coil "IS NOT A TOY", also this Coil Raises the Voltage Above 1200V.
SOCIAL
Intagram:
/ avilastechn
...
If you made it this far ............... have a great day !! :)
Remember to take care of yourself in this contingency !!
8 сен 2024