What is the material for backing of the door? The cost you said was 80, was that an actual door or just a piece of plywood? Great build I'm going to try this.
@@TheWoodlandReboot thanks I found the door today. As far as opening and the door what type mechanism did you use. Did u use a wood book and gater latch or magnets. What allows the door to open and close?
@@christenragland8982 I was planning to use the wood book option. In the end, I have added not mechanism because the door stays shut on its own, i.e. there is enough friction that it essentially acts as a magnet. I pull it shut and it stays in position. A slight nudge ... and it opens smoothly.
I was think about using a book and gate latch but don't think that will work since it will be in swinging door. What type mechanism were you planning to use.
Good question. Pivot hinges could definitely work. It depends on the design of your door. In my case, I made a light door and also supported it with a caster wheel, allowing me to use the normal hinges from the original door. Good luck with your project. Peter at the Reboot.