How To Make Cutting Disc For Dremel From Angle Grinder Cutting Disc | DIY TOOL 

Maybe because damage to these disks can cause them to shatter, so quite dangerous!

@@deepsudeep dunno, original ones are very fragile and i havnt exploded any homemade.

Many dislikes because they surely come from people who do not have a minimum idea of ​​tangential speed, centrifugal forces etc. and it is easier and more convenient for them to go to the hardware store. The cutting discs for grinders come with a limit warning 80 m / s but it refers to the tangential speed that if it is exceeded then the disc will burst. A 11.5 cm disc in diameter at 11.000 rpm it maintains a speed lower than 80 m / s and if you get 6 small discs of approximately 4 cm in diameter it is easy to know that at 30.000 rpm it will continue to maintain tangential speeds below the limit. I already did it, using 11.5 cm x 1mm or 1.2mm discs and with great care in the process, especially when drilling the shaft I already prepared small cutting discs for my Dremel and the results are fantastic, I have not popped a disc only and its life and performance far exceeds the original fragile discs (I own many of them but they generally disappoint me). I don't overheat my Dremel and I never work without protection. So ... go ahead with your channel dear friend.

most comments on thumbnail not watching the video

@@luciusirving5926 yes, i tried with 2mm thick cutoff wheel and works great.

Yep :D just experimenting with clickbaity thumbs on stupid lifehack videos.

Depends on your dremel power. This motor is 150w and i can cut steel with it, so pvc is not a problem.

I only burn my hand with hot glue. 💁Cant see why you need face mask, but anyway - better safe than sorry.

@@craftzars yea right.. i never use face mask before oh well just want to tell anyone that never have this experience haha.

Ou wrong video i was thinking you comented on cat tree video, yeah you totaly need to use eye protection when working with grinders and cutters!

@@craftzars hah! ok that's understandable. 👍

By that logic actual size cutting discs shouldn't be used either. They are sacrificial items. Their intended use is to be damaged. Besides, safety squinting is in full effect..

​@@adrn8400 yep safety squit is enabled so nothing wrong going on 😊

Meh, drill is too slow for patience 😆

I already mentioned in the description i needed dremel cutting discs but they were expensive at the local store. so I made it myself. and why did i need it? because smaller discs give you better access to areas where the angle grinder doesn't.

@@craftzars I see, thank you for clearing that up.. The picture in the thumbnail is what I was commenting on, that looks so DANGEROUS!!

It's the little circles he cut out that he's using, not the dish with holes in it.