Teşekkürler arkadaşım. Tam ihtiyacım olan devrre. Güzel çalışma için tebrik ederim. Başarılar. Thank you my friend. Just the circuit I need. Congratulations for the good work. Good luck.
Excellent video. Exactly what is needed. Everything I've seen used Arduino. Just need a single channel transmitter/receiver to operate a small servo. Will this hook up work with a 315 mhz transmitter/receiver? Thanks. Allen in Dallas
The IRFZ44N, MOSFET is just like transistor, when a small current is allowed through the gate, a huge amount of current will flow from source to drain. He connected the 5 volt supply to the source, LED to the drain, and the data output of that 433Mhz receiver to the gate of the MOSFET. When he clicks that button on the transmitter, it sends out a signal with a frequency of 433Mhz, which is received by the receiver and is sent through the data pin to the MOSFET there by lighting up the LED. I don't think it needs the 555 timer circuit, it should still work without it.
Yeah. Please explain what everything does, where each part came from, when they were made, how they were made, what matériels were used to make each component, what minerals were mined out of the ground to make the materials. Please kind sir, explain!
At one minute and twenty-eight seconds into the video a resistor is connected to Pin 3 and the text reads '1k ohm Pin 3' . The resistor shown is brown black orange which is 10k ohms, not 1 k ohms.
brother, please make 4 channel transmitter or receiver by using RF 433 MHz module in an easy way and longer range plzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzz