Simple example showing how to program Siemens Logo without software. Siemens Logo starter kit ►goo.gl/MRwZKJ Logo programming cable►goo.gl/DnvQ2X Siemens Logo 8 ►goo.gl/LMYmLE
Is there anyway to manually set this controller to turn on one motor for three minutes shut it off and then the same thing for three more motors and at the end of the cycle started over again without being a programming genius ?
For elementary programs is OK. As soon as the program becomes a bit more complicated it is very difficult or impossible to visualize properly. Unless you have masochistic tendencies..
Sir could you please help me create a usb programming cable for 230rc ( just like your cable). I am somewhere in Eastern Africa and I can’t find the cables for my PLC which I bought from Germany years ago. I can’t afford me new cable and there’s nowhere to buy in my country. Just the four cable which goes to the usb and their connection on the 6 PLC socket pins. I will appreciate your support Sir!
I have a Logo 230RC. When I power it up, it shows the input numbers at the top, outputs at the bottom. The day and time are in the middle and it is in RUN mode. I can't do anything except hit "esc" and "ok" which gives me access to set the clock and set the parameters. I can't figure out how to get it into program mode or add/change any of the programming. Do you have any insight?