Hello my dear electronics enthusiasts. Welcome back to the channel, today I am going to show you a repair for a red-brand television in which it keeps starting up and cannot finish the ignition process and the operating system is loading. It's a 40-inch Android TV, so I'm going to show you. Here I have it. As you can see, it started with the logo. And it stays in Windows chat like this infinitely. A. , There, as you can see, if the operating system tries to load again and again and fails to finish starting, here we have the RT 809 h programmer connected to the television. Here we put the button panel. For what reason? Because we had to open the TV and the button is a single button underneath and so it didn't fit us very comfortably and we had to place the buttons here. Here we have the computer, we have the TV that is trying to start and it has not just started, so the programmer is already installed, let's see here. Here we have the council, they will see if there is a connection between the television and the computer through the programmer, we turn off, remove the power. As you can see, the TV went off and we started again. We press the power key to start, but we do not have communication, so we are going to look for the communication, first we are going to make it communicate see, we are going to see and we are going to start the software, we are going to see the parameters. There we are having information that comes from the television, we are going to do it. And we will open then again. Two section. Not anymore, as you can see, that's where we start getting information from the TV, it's trying to start over and over again. So we are going to do the following, we need to enter the recovery mode to eliminate all the information, the one that it has so that it can then start correctly. Well, let's go into debug mode. Let's throw an unknown command help, people try helpe. This is just the information that the TV gives you about what you can do through the commands. Let's go straight here, he's not going to let me do anything. If I put recovery it won't let me. It tells me that I put brissette on the unknown command and the television resides there, but it has little command, the truth is, this television has little command, so what can we try through the command? The ribaucourt try to enter in a forced way as there it will stay turning and it will not start. We are going to turn it off and we are going to connect it again. There it is turned off, you have to start giving that command. And there the recovery menu options appeared that we can perfectly move it around here. We delete the cache and do a reboot directly. There it is there as you see. I'm telling you, this is the remote control on the sun. , Ready. Install. Allow. And there it is. Finishing installing here I leave this repair, my dear enthusiasts, electronics. If you have any doubt, suggestion or question, you can always leave it in a comment box. It helps me a lot if you subscribe to the channel, give it a like and above all share this video.
26 авг 2024