How to remove the transmission in an HONDA CR V 2.0L 2003~2006 K20A MRVA 

did you do it

@@Godsxeed yes I did it’s been a few years now and no issues besides a slight leak from the transmission casing being cracked from getting dropped(not from install, my buddy dropped his end when we were transporting it from my trunk to the garage). Wish I just swapped out the casing but something I didn’t think about. Just needed the car to be finished.

Did you ever find out?

Torque converter

No. You'll need a new transmission ecu and different wire harness.

It's a 2.4 shown in this video

Same question

Yes crv and element share same tranny

The other motor mounts.

Thanks

A support bar across the top to hold the engine or they have something under the engine holding it up. They have 4 mounts and 3 attach to the trans.

It’s easy. One day job for me and this my 2nd time doing a trans.

Just take pictures use tape and write on it for the connection put bolts back in the parts you take off.

should be easy to deal after intake manifold is taken out.

I know that's starter bolt it's ridiculous maybe a little Japanese girl could get her hand in there