How to Repair a Bad Flooring Joint | Ask This Old House 

Ask This Old House general contractor Tom Silva repairs a piece of wood nosing that was poorly installed and resulted in a bad joint.
SUBSCRIBE to This Old House: bit.ly/SubscribeThisOldHouse
Time: 1-2 hours
Cost: $20
Skill Level: Moderate
Tools List for Repairing a Bad Flooring Joint:
Reciprocating saw [amzn.to/2NDitD3]
Chisel [amzn.to/2MOli4n]
Nail pulling pliers [amzn.to/34cRnIN]
Hammer [amzn.to/2NR7TIT]
Track saw [amzn.to/34bBmCW]
Mortising machine [amzn.to/2MItK5v]
Shopping List:
Wood glue [amzn.to/2ZCXhzl]
Construction adhesive [amzn.to/2Lc02Ut]
16d nails [amzn.to/2L90u5B]
Floating tenons [amzn.to/2L8jm4W]
Steps:
1. Use a dull chisel to lift the nosing slightly to allow room for a reciprocating saw blade. Use the saw to cut the nails that hold the nosing and then remove the nosing.
2. Pull the nails from the board, then scrape any old adhesive or filler off the nosing.
3. Lay a straight edge on the widest gap on the flooring and then use a track saw or circular saw to cut all the flooring evenly.
4. For the area where the saw blade can’t reach, chisel out the floor boards so they’re flush with the other boards.
5. Check the fit of the nosing.
6. Mark lines on the nosing and the floor boards for the location of mortises and cut them on both surfaces with a mortising machine.
7. Use wood glue to install the floating tenons into the mortises of the nosing.
8. Apply construction adhesive to the subfloor under the nosing and wood glue along the edge of the flooring.
9. Bring the nosing in, line up the tenons with the mortises on the floor, and slowly tap the nosing in place with a hammer.
10. Once the floor joint is tight, secure the nosing in place with 16d nails.
About Ask This Old House TV:
Homeowners have a virtual truckload of questions for us on smaller projects, and we're ready to answer. Ask This Old House solves the steady stream of home improvement problems faced by our viewers-and we make house calls! Ask This Old House features some familiar faces from This Old House, including Kevin O'Connor, general contractor Tom Silva, plumbing and heating expert Richard Trethewey, and landscape contractor Roger Cook.
Follow This Old House and Ask This Old House:
Facebook: bit.ly/ThisOldHouseFB
Twitter: bit.ly/ThisOldHouseTwitter
bit.ly/AskTOHTwitter
Pinterest: bit.ly/ThisOldHousePinterest
Instagram: bit.ly/ThisOldHouseIG
bit.ly/AskTOHIG
Tumblr: bit.ly/ThisOldHouseTumblr
For more on This Old House and Ask This Old House, visit us at: bit.ly/ThisOldHouseWebsite
How to Repair a Bad Flooring Joint | Ask This Old House
/ thisoldhouse

Хобби