How to Replace a Stack Switch using Cisco DNA Center RMA Workflow 

Thank you for the video however, this process will never work a fully lan automated environment. You should mention that the device should be onboarded first either thru pnp or discovery for this process to work. if it's a brand new switch, before connecting the device to the failed device uplink, you should connect it somewhere and onboard it. Ideally it's long process than traditional RMA.

This is replacing an entire stack, or a single member of a stack?

I had a fabric stack member fail and when I replaced it , it did not automatically receive the port configuration from the master. I had to manually configure the ports using interface range command. Do I have to follow the same replacement process in this video?