How To Replace Jeep Wrangler Transfer Case Output Shaft Seal 

If you have any questions about this video or the procedure post here

I kept seeing fresh oil drops under my jeep thinking it was motor oil until I realized it was further back then the motor, took a closer look and seems like I need a new output seal. Thanks for the help. Informative video

I would remove the rear housing and replace the seal and the bushing inside the housing. Complete job done and no more leaks !

Thanks for the video!

Thanks for the video, where did you get seal or what brand is it?

Great job. So, it has been a couple years- is that seal still holding?

No nicks, it’s a pretty good amount of fluid leaking out. I pulled the transfer case to inspect it better.

when you mentioned a socket or something to hammer the seal in, you want it to be inside the rim or does it have to be on the outside lip?

hello, is the an Automatic or a Manual transmission, 2) is this the same procedure for a transmission that does Not have a transfer case. fyi, I have an AX-15 5-speed transmission, a 2x4 unit

I have an np231 and the slip yoke broke on the output, can I just pull on the broken yoke and it should slide out?

I tried to replace it just like what you did but it fought me so hard I ended up removing the housing to work on better Now the problem is that the housing did not come back on perfect bolts did not align with holes could I did it wrong Please I need help

I’ve replaced seal twice and there is still a leak. Any idea of what it might be?

One has the

Hesoka ! It came off soit has to go back on ! Jusrotate it till the hoes line up ! Drain hole shouldend up on the bottom !