Nissan Tiida Versa Rear Light Bulb Replacement how to replace break light If this video has helped you, please subscribe to my channel. Appreciate your support. Thank you.
This video is AWESOME I was able to change the light in my mom's car in four minutes, she was very worry and now she is very happy and I regained my favorite son status. thank you.
Than you. I'm a mechanical idiot and I appreciate the very clear instructions. Good tip on the magnet, didn't have a magnetized tool so I stuck a STRONG one on the base of my 10mm ratchet. Took less than 5 minutes after watching your video!
Thank you! I tried looking at it myself and couldn't figure out how to get to it. This video showed it very easily. I followed the steps, done in about 5 minutes. I took the most care in replacing the nuts so I didn't drop them. Thanks for taking the time to make and post this!
Absolutely correct! Very poor human engineering here. Almost like they designed the car then thought ‘Oh, we forgot to design access to replace the globes’🥴
excellent instructions, I did the back up light on mine, a little fiddly, the key is to take your time, mine took 15 minutes, and managed not to drop the nuts.
Thanks. That was really useful. But I dropped the nut and ended up destroying the boot lining trying (unsuccessfully) to get it back. But yeah, your video was really helpful. Absolutely agree with Sergei K.
Great video! I only had a regular socket so I put it over the lower nut and then put the driver into the socket to turn it. I needed pliers for the upper nut because my wrench was too large. Learned a new skill today.
Thanks! I fixed my park light using this video. I used a bit of blutack at the end of the socket as I have a large hand and was paranoid about dropping the nut (for the back panel) when putting it back in as my socket wasn't magnetic.
Could not figure it out without your help. A regular 10mm socket worked for me, not the deep one. For the upper nut I used a 10mm wrench, the ratchet won't work. Also no need to disconnect the wired, just pull the whole light assembly out.
Just a friendly note. Do NOT use bare hands to touch light bulbs, there could be oil or grease on your hand to cause hot spot on the bulb, and it will burn out faster.
I cannot push the light off for the life of me. I don’t know how he does it so way with one hand. Had the same issue before when we had to replace a different bulb. Took it to a shop and it took like 4 guys to get the darn thing off.
Yeah, it was very hard to push that the light housing off. It took me a long time to get it. Like the video said, push inward (toward the car) and also backward at the same time. I would just beat the crap out of the designer whoever designed this crap. It's so hard to get to the screws, and it's so difficult to remove the housing.
@@yingcluk The housing is still waiting for me to yank it away from the car - it's been like 2 days since I removed the nuts. Wondering if I can spray a bit of WD40 to the screws to loosen them - how did most of you guys do it beside using brute force?