SUMMARY FOR ANYONE THATS IN A RUSH: 1.) Remove USB from Computer 2.) Remove all Connections (but power cord) 3.) Make Sure Device is Off 4.) press Deck 1 & Shift key on left side same time & then press on 5.) Check all buttons and panels to make sure they light on 6.) Once everything is working, press both syncs at the same time 7.) Turn back on controller Done
Thank you! Thank you! Thank you! 🙏🏾🙏🏾 I just updated my controllers (Pioneer DDJ-SR) firmware & driver. And after doing that, I connected my controller to SeratoDJPro. My controller started up as usual with the whole unit flashing lights but the buttons & decks were unresponsive. I spent the whole weekend uninstalling & reinstalling the driver and damn firmware. And my controller still didn’t work. I tried this reboot to my controller, & it worked! We back in business baby 💪🏾 Thank you again!
All its good but you only have to unplug the controller from the computer, trim to low knobs need to be at zero the fader all the left then do his procedure, once in reset mode check trim to low knobs volume need to be zero to then go thru each half point then max your see your lights come on and should go with your increases
Everything was wavy, until the connection from my ddj-sx recognized my MacBook. I am using a new USB adapter also. Any help would be greatly appreciated.
You click the que on the right side but your crossfader is on the left. How is that fixed. You shouldn't hear nothing if your crossfader is to the left on the right side
He more than likely had the crossfader switch on the right hand deck (under that channel) on the left or thro. You can assign any or all channels to one side or thro, if 'thro' is used the crossfader position has no relevance, I just checked, He has all his channels on 'Thro'
I have an issue with my Ddj Sx2....I load a song on Deck B ...I lower my Fader and Move the cross fader to Deck A and it still plays ....I think my decks have inter changed