Hi There, You guys may have had difficulties many times to start the engine. You have the engine cranking but no start. One of the common problems is faulty camshaft position sensor. In this video I show you how to test the camshaft position sensor. I Also explain the sensor wiring diagram, I point to each wire, then I show you how to test each single wire on the cam sensor. After testing the wiring, because there is no internal resistance measurement for the cam sensor, I show you how to read the sensor output signal using an oscilloscope and how to diagnose the sensor operation by reading the sensor's waveform.
What is covered in this video:
- Intake camshaft position sensor location
- Camshaft position sensor wiring diagram analysis
- Camshaft position sensor Power supply test
- Camshaft position sensor Ground Circuit test
- Camshaft position sensor Signal Circuit test
- Camshaft position sensor removal & inspection
- Camshaft sensor output signal (waveform) reading and test using an oscilloscope
You might be interested to watch the following videos too:
Crankshaft Position Sensor Diagnostic | How to Test Crank Sensor with Multimeter & Oscilloscope
• Crankshaft Position Se...
How Immobilizer Works | Transponder Chip, Immobilizer Components, How to Bypass Immobilizer
• How Immobilizer Works ...
CAN-BUS Explained | Everything You Need to Know About CAN-BUS | CAN-Bus Diagnostics & How It Works
• CAN-BUS Explained | Ev...
Don't Replace ABS Module Before Watching This | Repair ABS Module for Motor & Valve Relay Error
• Don't Replace ABS Modu...
Join the channel for more videos and more support:
/ @automotivediagnosis
Please follow us on the following social media too:
/ autodiag001
/ automotivediagnosis
#p0340
#p0011
#p0014
#p0016
#p0017
#enginetiming
#vvt
#enginerepair
#camshaft
#crankshaft
Disclaimer:
Any information contained in this video is just the understanding of “Automotive Diagnosis: Cars Repair & Training Guides” and it is not an official guide or reference, so everything provided in this video is just a share of our experience and understanding and they are provided as a courtesy for your reference only. So, if you are using any part of this video, use the information at your own risk. We highly advise you to check the manufacturer owner’s manual before performing any act of removal, diagnosis, inspection, or repair on your car to know about what you are authorized to do on your car, what the correct and legal procedure is and what risks might be involved, also viewers are strongly advised to consult a licensed person before any sort of inspection or repair. Due to the factors beyond the control of “Automotive Diagnosis: Cars Repair & Training Guides”, we cannot guarantee against improper use of information or tools or systems, or the procedure provided. “Automotive Diagnosis: Cars Repair & Training Guides” disclaims any damage, injury or loss caused by your decision to follow the steps provided in this video.
10 июл 2024
