HOW TO USE A RESISTOR TO GET OUT YOUR SRS AIR BAG LIGHT 

It is a temporary bypass until you get the faulty airbag replaced

The other airbag will work? Since you are only bypassing the one is faulty?

@sc0rpion604 yes

2.2 Ohms

Could you please answer me with a simple yes or no to be sure. Thank you

I know about car computers so that how I know but you can use 2.2 ohms 3.3 2.5 which is easier to find thanks for stopping by

Every Socket that go to the airbags need a 2.2 ohms resistor

@@MrtalentedReid okay I’ll try it.. thanks for sharing

2.5 ohms

@@MrtalentedReid thanks a million u have a great night..I am in New York where ru located??

@@MrtalentedReid2.5 ohms 1/2 watts will work ??

Bro 2.5 ohms 1/2 watts or 1/4 watt Amazon have only 2.2 ohms can use the 2.2 ohms 1/2 watts or 1/4 watts I am sorry to bother u..

3.3ohms 2.2ohms 2.5ohms 1/2 watts

2.2 ohms half watt

@@MrtalentedReid thank you sir. Do you know how to remove/delete permanently the SRS?

@brylontoc6140 I don't recommend deleting it just do the temporary bypass

All the vehicles I service use 2.2 ohms

2.2 - 3.3 - 2.5 - 2.7 ohms one of those should be good

Your welcome thanks for stopping by happy new year

Am doing it for yours no fire and it is wave signal won't cause fire

Putting fuse gonna damage the computer program for the airbag system

Use A 2.2 ohms resistor

@@MrtalentedReid thank you bro. When it bypass the other airbag will work? Because it probably gonna be a while until i change it. Since it will cost me probably $2k

@sc0rpion604 yes take your time

2.2 Ohms

As possible to use 2.2 ohms for Chevrolet impala 2006

Yes 2.2 ohms mostly use in all make

@@MrtalentedReid great, and how many watts? A quarter, half or 1 watt?

Half

Yes

Sorry I was supposed to say 2.2 ohms but was driving

Thanks brother

@@MrtalentedReid I am very happy you get back me ..don’t be sorry bro I am sorry for bothering you bro thanks again you have a great day.. I’m go and get some 2.2 ohms 1/2 watts or 1/4 watts resistor from Amazon..

It just switch off the lights

Incase of accident the airbag won't deploy@@MrtalentedReid

It won't if the air bag faulty

2 - 3 OHMS Resistor

BOJACK 50 Values 1350 Pcs Resistor Kit 0 Ohm-5.6M Ohm with 1% 1/4W Metal Film Resistors Assortment a.co/d/7SkfaP9

That will work also 3.3 2.5 ohms

@@MrtalentedReid thank u so much

3.3 ohms resitor it is a bypass

2.5 ohms

Also 2.2 ohms 0.25w 2amp

2.5ohms or 3.3ohms 1/4 watts

@@MrtalentedReid thanks..will try again tomorrow 👍

You are welcome

@@MrtalentedReid tried 3.3 and 2.4 (since the shop dont have 2.5) but didnt work. Will try again to get 2.5

Okay

2.2Ohms

Did you ever get it done? I have a 2016 Honda accord sedan and I'm trying to figure out how to put the resistor on the curtain bags

@smallsplayz9740 same as the other

You can use a 2.2 Ohms Resistor

I did but the light still on. It's so confusing

Maybe you missing something do further checks

Possibly, but is this problem on the passenger seatbelt ?

Yes check if there is any broken wires under the seat

Ford mostly use 3.3 Ohms 2.2 Ohms 2.5 Ohms one of those should work for you

2.2ohms thanks for stopping by

Oh yes 2.5 can also be used

@@MrtalentedReid man thanks for the fast response! Useful videos you have. So the designated resistance is 2.2 ohms ford galaxy RCM/SEAT BELT PRETENTIONER/SRS but I can use a 2.5 Ohms resistor? Do you know where I could find a wiring schematic for a 2008 ford galaxy tdci? I also have a mystery loose wire. Can't find a wiring manual. Thank you!

Oh wow I don't have any idea about how to find wire diagram but I always know how to trace wires and find them lol 😆 lots of work though sometimes 2.5 good

@@MrtalentedReidhow many Watts 2.2ohms resistor for this? Thank you!

Yes it can

@@MrtalentedReid ok I bought this car with rebuilt title so I figured this would of been done to it before I bought it. The airbag light was on on dash. Upon further inspection they had put tiny resistors in the driver and passenger curtain air bag connectors and the driver seat belt connector. I replaced them with 3ohm models. Hooked battery back up and the airbag light is still on. The knee air bags looked fine. And I haven't managed to get the steering wheel cover off yet. Didn't have the right size screw driver to push into back of the wheel to get it to pop out. But let's say it's good.... What else could it be or should I check?

4pcs Car SRS Airbag Simulator Tester Testing Instrument Resistor Bypass Fault Finding Sailsbury www.amazon.com/dp/B08XB9WT2M/ref=cm_sw_r_apan_glt_fabc_65VVHVRRXC42WJ6P0D6N

Hopefully that should help if nothing wrong with modules for the system

2.2 ohms

@@MrtalentedReid thank you so much! and a super fast reply! Be well, and have a great day!!

Your welcome have a blessed one

@@MrtalentedReid you too, sir! One more easy question for you: so, at this point both my front bumper impact sensors are disconnected. Do I need them reconnected for this to work?

Yes they need to connect

2.5ohms or 2.2ohms

2.2ohms or 3.3 ohms

Yes

@@MrtalentedReid how about for side airbag for side seat? 2.2 ohms? because i bought a 2.0 ohms and its not working.

Try 3.3ohms and make sure no open circuit it there and the control module is good

2.2 ohms

You talking about the parking assist sensor?

Thank you

2.2 - 2.0- 3.3ohms one of those should work

BOJACK 1000 Pcs 25 Values Resistor Kit 1 Ohm-1M Ohm with 5% 1/2W Carbon Film Resistors Assortment a.co/d/gVzKog3

Same process

Same procedure

Google the ohms of your air bag system

It best to Google it to see what Ohms resistor use on your car

@@MrtalentedReid I have a Honda Fit 2012 and I’m searching it but it’s not clear… do you know what ohm works for it?

2ohms resistor if that doesn't work for your car try a 10ohms

@@MrtalentedReid ok will try I’m gonna try 2.2 as well since I read that as well somewhere

Ok

2ohms resistor

@@MrtalentedReid Thank you! Can I hook the resistor up to the plug that meets the seatbelt, instead of opening the dash?

If it is the seat belt having issues you can but if it is the one in dash area you have to remove some part of the dash

ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-1bohzeqWW8I.html

2.7 Ohms

2 Ohms

Yes it can work you just have to Google the right ohms resistor for it or go to Amazon and get few air bag bypass resistors

@@MrtalentedReid Google isn't really telling me anything, I have a nissan quashqi 2007, should I go with 2.2 and 3.0 if they don't work go to 1.5ohm ? Any advice is greatly appreciated

3.3ohms resistor will work

Thanks for your help

Your welcome

Thank you

10 ohm resistor color code 4 band resistor is brown - black - black - [Tolerance]. The color code of the 10 ohm resistor with 5 band is brown - black - black - gold - [Tolerance]. 100 ohm resistor color code of 4 band resistor is brown - black - brown - [Tolerance].

Thanks for stopping by

Nice one

Thank you

All cars that I come across use 2.2 Ohms Resistor

To be honest I don't remember the value of it but a 2.2 Ohms work

B102800

Different cars sometimes come with different Ohms air bag systems

Afer stepway what résistants please

3.3 Ohms

You also can use 2.2 ohms depends on the car you have

@@MrtalentedReid 2.2 was the special number

That's what the computer in the vehicle recommend thanks for stopping by

Résistance spécifique pour bypass airbag sandero 2015

English please

Merci bien