How to use the Firex Gas and Carbon Monoxide Alarm 

Glad I could help and thank you for watching

Excellent idea I have a gas stove at my house so that’s the thing I worry about. Good luck. Stay safe and thanks for watching.

You’re welcome good luck and thanks for watching

Yeah, I put mine in a little bit too close

@@TomLeeman Was to write the same comment. Kidde state a minimum of 5 ft. But recommend actually 15 ft or more. I set mine as around 20 ft from the natural gas fireplace up from the ground on a small table. If you use a propane tank, it should be low to the ground to the more effective.

It's a good way to test to see if it works tho

You are welcome

Thanks for those kind words I appreciate it

Thanks and have a happy holiday

Thanks and have a happy holiday

I have to go back and make a new one

You're welcome!

That’s a good question I have to do some research on that one

That's normal. a number above 200 and Gas shows when you press reset.

@@luimobilefixes5279 thanks for that info because he

low battery is my guess

I’m not quite sure you could try and see just to test it out. I don’t have this one anymore. Good luck thanks for watching.

@@TomLeeman i see

That’s a great question I would have to research it a little bit to find out

It says it needs to be replaced every 7 years and it will start beeping letting you know it needs replacement

Glad I could help

I don’t know I hope that it’s kind of weird might have to take it back and get a different one

Maybe not completely dead ; just feeling like it by being up all night!!!

Have your local power company come over to test for carbon monoxide and or gas. I love in MI and they will come for free to test for them

I think you need the batteries

Thank you so much Tom! I hope you have a wonderful day!

It will chirp unless you put the battery into it

You are correct, sir

@hardworker1957, The unit he has detects carbon monoxide AND gas leaks.

Good question I’ll have to do some research. You may have to reset it.

Means it's on battery backup, plugging it in will resolve this.

It was plugged into wall outlet when this screen glitch occured. I own two of these detectors & have switched them from each other's location outlet but just the one unit had this problem.

@@coma5553 is the outlet receiving power? Have you tried to put the working alarm where the seemingly faulty one is?

The outlet is fine & I've moved it to another location & installed a new one in it's old location

Do you have a gas furnace? If you do, you could do that they’re 50 bucks though each I don’t know if you need to maybe the bedroom where you sleep in the kitchen if you have a gas stove

I just set mine up, it’s just a dot blinking . What does that mean 😮

​ did you figure out what it means? Mines doing the same thing

It’s been a while since I made this I would have to do some research on that

I have to do some research on that one and find out thanks for watching

It's mean low battery. If you look at upside down It's LB low battery

You're welcome!

You may have some gas for carbon monoxide above the level that should be

Check the batteries and make sure that they’re charged. I have a little battery tester that I use.

I’m sure they have one that’s like that

Thanks for the wonderful notes and kind words and thanks for watching

Sorry