This video was perfect instruction. Thanks to it, I got my old gasket out and new gasket in in less time than the video needed to explain it. No putty knife needed, nothing broke, even the corners were easy with the instructions given. Thank you so much!
Thanks for this video! I purchased a new gasket for my KitchenAid refrigerator and replaced the existing one, applied the petroleum jelly but it's still not sealing properly. Some broken magnets came out of the old gasket and I purchased some new magnets but I'm not quite sure where to insert them? Any help appreciated.
Hello, I recently installed a new Samsung fridge door gasket thanks to your help, now I have water line break issue. I first repaired it with a shark bite online union and it lasted bout one year and leaks from the union after you let off on the water dispenser only. I put in a new shark bite union and started failing days later and only when you let off of the water dispenser. I contacted sharkbite tech support, they explain that that union is discontinued and suggested the John Guess brand union and I got same problem on this 5/16 plastic water line. Should I try copper couplings ? What do you suggest ?
The water line goes along the back of fridge, exposed, it's a white plastic tubing. I repaired an online hole with a Shark bite coupling, it lasted one year. When you use the water dispenser it flows fine, but when you stop, somehow it causes back pressure and it make water spray out of the coupling union. It happened three times and with threw new couplings, two were sharkbite and the third is John guess. It's a 5/16 size and I made sure all my cuts were square and I did not sand the ends. Shark bite tech support said that part is discontinued and referred me to buy John guess brand. WHAT do you think? Should I try copper coupling? , there has been No plumbing work or other sites near by. Let me know your expert advice.