Finally someone that showed me how to wiring in the AUX switches. lol Thank you I must have watched 20 videos that never showed were the power came from.
I thought I remembered there being wiring for the upfitter switches inside the cab but wasn’t sure of the location. Finally found someone that showed it. Thank you kind sir!🤙🏻
I just wanted to give you a shout out and say thank you for showing where those wires come out of the cab under the hood. I would have never found them if it wasn't for this video!
Dope! Not as bad as i thought it would be to locate that harness after watching rhis just got a new service truck and wanted to run strobe tail lights and needed to have it on that switch thankyou!
I had the same setup with the BuiltRight dash mount and a bunch of ram mount parts. I hacked the desktop stand for the Furrion monitor to get the ball mount.
This video is one of the best I have seen, keep doing this stuff for us. Would bringing one of the Upfitter 5 or 6 wires that are on 40amp fuse to the inside make sense in the way that you can wire multiple gadgets to a inside distribution point, how difficult would it be to get a thicker wire through to the inside from the upfitter box?
Best video I have watched regarding this, my question that wasn’t answered below is when you tucked all those wires in the Super Duty compartment do you get any rattle between the cigarette adaptors?
Very Nice and good job, Just have one question why did you go with the cigarette lighter adapters and instead of just hard wiring each component to the corresponding switches? I still need to do mine and i am still trying to figure it all out. I like the way how you took the time to show each step on each panel.😀
@ 6:05 you said to connect one of the four pass through wires to one of the relay wires. Where did you find the four pass through wires in the engine compartment?