Since there are no more ports open on the power supply, what if you wanted to setup another driver for say the Z axis motor? Can you just run two wires to one of the ports on the power supply?
hy brother i have laser machine 100 waat can u help me when i turn on machine with watter coller the lcd of machine bilinking and also bilinking light of ruida contloer light no 15 with beep plz can u tell me what is problem
Hi Patrick Thanks for you video. I change my controller and used this info. Im a left with a slight problem. The laser fires when traveling to its origin and then when it returns when job is completed. Also there is no variance of heat. It wont fire at 21% but full power at 22%. This didn't happen with the old controller. I have searched and found no help anywhere. Hope you can. Thanks Scott
I want to use a controller like the one you use here, but I want to move two motors for the Y-axis. I want to use two drivers but the same signals for the Y-axis feeding both drivers, thus both motors. Will the motors stay synchronized?
You can do this in the LaserCAD software, or you can wire the A and B coils in reverse. That is to say, put the wires meant to be on the A+ and A- to the B+ and B- and vice versa.
Great, I`ll do that. Do you have videos for LaserCAD? I used to use inkscape but recently upgraded to awc708 board so I guess i need to learn how to use laserCAD
This video might be intended for "limited" abilities people - Like those that just can't figure out how to skip a section of a RU-vid video. *hint* *hint* ;)