How to wire these NOV SIGHT HALO SERIES 6” lights into your auxiliary switches 

Thanks for the demo. I installed on Cayenne with Auxbeam 8 gang. 2 sets took 6 slots. 2 for actual lights, 2 for amber, 2 for white. I wanted to control one set drl colors independently of other and hence 3 slots per set.

I. My rough country light install video, I used 2 aux switches. 1 for the DRL amber or in your case halo and then another switch for the actual bright lights. That would suck tho to have to use 4 aux switches. 2 for the halo colors and 2 for both bright light colors 😂

I am in the same boat! Every time I turn my auxiliary switches on it works. I have the daytime running light to one switch in the main beam to another switch. When I turn the vehicle, the Novsight harness is turned on and both buttons are illuminated with the color white. The halo is on and it’s white. Confusing, but there needs to be a trick. Someone will figure it out.

Thanks bud. I understood how to get that but I thought you discovered the grail and was able to control the entire llight capability through the factory aux switches. I am going to delve in deeper to see if I can figure this out without tearing into the switch system or like you said, adding the switch in the jeep. Thanks for the insight!

Two separate switches to mess with. Worse than driving and using your cell phone.