The feeling is surreal. You had someone close to you-one moment they were there, and the next, they're gone. The void they leave behind is something that can never truly be filled
@@marios_ideas My heart goes out to you sincerely. Even though we're strangers to one another, I feel your pain. May we all find peace and acceptance when the inevitable happens. 💜
And also better to know, what i did is , i can control touch sensor with audrino, and audrino with touch sensor.... So audrino itself can save power when task is finished....
I have wondered if there is a way to add a signal to these touch sensors to toggle them from an arduino. Operaton would be - activate to latch output and power an arduino - at end of operation, arduino toggle touch switch to drop output and kill power to arduino I have used bi-stable flip flop switches but this touch sensor would be useful if it could be toggled via arduino and if it could handle the power for the arduino.
Not sure I understand your question. If you connect the touch sensor to the same power supply and connect output to 5v pin of the Arduino and also connect Gnd pin of Arduino to negative side of power supply then you will be able to power Arduino this way. We are of course talking about self latching sensor here
@@marios_ideas After powering the arduino and running the operation I want to power down the arduino. Disconnect the power by toggling the touch switch by action of the arduino. Power itself down.