Тёмный

HP Laptop Charger Disassembly and Cable Repair 

BLworkshop
Подписаться 202
Просмотров 4,5 тыс.
50% 1

HP Laptop Charger Repair - very hard to open it

Опубликовано:

 

18 сен 2024

Поделиться:

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист
Посмотреть позже
Комментарии : 16   
@wuzzym
@wuzzym 10 месяцев назад
Had the same charger and the connection was loose and wouldn't charge properly. Was tryna find a way to fix it myself but after watching this video, I was glad that I went ahead to purchase another charger.
@Bertronics
@Bertronics 9 месяцев назад
you are totally right, its not an easy open and fix design
@sujitpachode3207
@sujitpachode3207 4 месяца назад
Where did u buy new one ?
@wuzzym
@wuzzym 4 месяца назад
@@sujitpachode3207 I bought a replacement charger from an electronics shop. Same wattage but not from HP. Only issue was that it was a little loose and had the tendency to disconnect if the wire was moved slightly.
@sujitpachode3207
@sujitpachode3207 4 месяца назад
@@wuzzym does it work until now , any harm to laptop?
@ehsanaali2798
@ehsanaali2798 7 месяцев назад
USA used to have descent design engineering. Now look at their HP charger design! Disaster. If your DC jack breaks or the cable wears off then you have to buy a new 70$ charger. It is so difficult to replace the cable. Stupid design.
@Bertronics
@Bertronics 7 месяцев назад
I Totally agree with you
@estebanjuliandipalmamartin3581
@estebanjuliandipalmamartin3581 6 месяцев назад
You put cyanoacrylate to the duck tape and the what ? Thanks i´m electrician too
@Bertronics
@Bertronics 6 месяцев назад
i put superglue and dry fast spray on it to secure the duck tape edge to not get loose soon
@DolezalPetr
@DolezalPetr 11 дней назад
Worst charger ever
@Bertronics
@Bertronics 10 дней назад
Like it is not intended to be fixed 😉
@SumanNathThePP
@SumanNathThePP 9 месяцев назад
The 200w charger has 5 wires... Any ideas how they are arranged? Do both the blue wires go into one connector?
@Bertronics
@Bertronics 9 месяцев назад
usually the blue wire is considered as data and should be soldered or connected to center pin
@ehsanaali2798
@ehsanaali2798 7 месяцев назад
The charger draws a lot of current. That is why you need 5 wires. 2 wires for + and 2 wires for - and one wire for sensor data.
@killheist173
@killheist173 2 месяца назад
Is it okay to use any other compatible charger other than hp
@Bertronics
@Bertronics 2 месяца назад
yes under 2 conditions 1- charger should have a data line like the blue wire in this one "in some HP laptops this wire is not a must". 2- current(amps) should not be below the laptop's needs
Далее
Most common fault on a Dead Laptop
23:52
Просмотров 2,3 млн
130W USB C Laptop AC Adapter Teardown, what is inside?
11:15
Dead Toshiba Laptop Power Supply - Can it be FIXED?
16:48
Sửa máy mát xa cầm tay chập xạc
10:59
Просмотров 4,5 тыс.
{1001} Laptop charger repair, not turning ON
18:03
Просмотров 25 тыс.
HOW TO FIX REPAIR LAPTOP CHARGER CABLE
4:27
Просмотров 30 тыс.
Changing the cable on an HP laptop power supply
12:31