Husqvarna 125b: Carburetor Install 

I watched parts of 2 others before finding you. You were the best. Enjoyed your presentation. Thank You.

Well done mate! I followed the video step by step sitting in my chair in front of the computer. I've done this before but it took me twice as long and much harder the first time.

Great work Rob!

Definitely helpful.

Nice video. Clear, concise, great editing. I see you have some great help in your shop. You deserve more subs. Cheers!

Thanks for your help 👍

Thanks so much for this video!

Thanks for the super great tutorial. I checked the spark, good. I checked the exhaust, good. I replaced the carb and gas, good. Still will not start. It's a relatively new machine 😞Any OTHER ideas?

Nice video, thanks.

Worked that’s weird but it better than a repair bill

Hi Hasqvarna friend. Once the new carburetor has been installed, does it come with the adjustments so that no adjustments are needed by the person who bought it? I noticed that you just started the rebuilt carburetor on your blower without adjusting the High and low adjustments. I also noticed that you did not have to do anything to the idle screw.

Everytime I start mine an get the high an low perfect it'll die after prolly 2min of use. Can't figure it out?

I followed this video and even changed my spark plug. It took a couple minutes to fire then it ran great, for probably 5 minutes then it bogged down and would not start again. It felt a little hot but not to bad. Any help?

That rubber plug in my fuel tank was way harder to remove than the one in your demonstration. I used a screwdriver just like you did…and was wondering if I was going to be successful. I have a question…after installing a new carb…my 125B started right up…just like it was factory new. However…it seems to run fine by the sound of it, but it vibrates more than it did before when blowing leaves. Any ideas?

Hey its Tristan