HX One Tonner Build - Fitting a 4 Link Suspension and 9 Inch Diff 

Thanks Mate for watching the channel. Well if you proud of it thats all that matters. Agree they are becoming more and more harder to find good ones.

No dramas at all. Hope it helped

Thanks Mate. Was not too bad just time in measuring everything up and getting it right

Hey Mate was not too bad to do. I think it took about 2 days and biggest part is making sure all your measurements and alignments are spot on.

Thanks heaps Mate. To be honest I dont know any of that what you mentioned. Its my first time installing/setup of a 4 link but appreciate letting me know. I will look into them for sure. With the Axle tubes is that scale likely to flake off and contaminate the oil? Would you be best to pull the axles out to clean this out?

Definitely take the axles out.I'd be stripping the whole unit to check all the parts you payed for, thats just me.I've found swaff in wilwood master cylinder before so I check everything. I used a 3inch ball hone to clean out my axle tubes but I did alot more welding than you have. Some emery tape on a 13 mm tube in the battery drill will do and use a rag with thinners to clean up. I didn't see if y housing had a drain plug (ford never did) now is the time to put one in.use an 18mm o2 sensor nipple and any jap plug will fit.My race diff lives on 3 lt of oil if you over fill the housing you can have a world of trouble with the axle seals. Be careful when setting up your brake master. The old proportioning valve is for disk front drum rear so you may not need it. Hopper stoppers have good information on their site to explain what you need.

Thanks mate for all that good info. Will defs pull the axles out to check.

Thank you! Cheers!

Thank you! Cheers!

Thanks Mate. Was not too bad to do just takes time

Thanks Mate

Cheers.... Making progress slowly

Thanks for the Sub Mate and enjoy :)

Thank you! Cheers!

Awesome, thank you!

Watts bars or ogee single bar around pumpkin level at ride height should be on perpendicular. 90° to 4 links...

You're welcome

Thanks Mate. Appreciate the feedback. Bloody sweet Ford you building. Subbed back at ya.

@@ShenkeGarage awesome 👏

Hey Mate I have been told the caltraks work great. The only reason why I went 4 link was the adjustability of it. Pretty easy to adjust the ride height etc

Hey Mate the 4 link kit was approx 2k

Thanks Mate. At this stage I have not really thought about the engineering yet. I think there are a few guys that can do it.

Hey Mate. The 4 link will need engineering and then I believe it can be Mod plated after that.

Hey Mate. If you go down to some of my first videos there is a video called how much to build a shed. All the details are in that and there is a cost breakdown.

Hey Mate the width is 1560 from flange to flange where the wheel mounts to.

@@ShenkeGarage thanks mate I got a old hx tonner too but don't know if I will go with the 4 link on it

Not sure what you mean by this comment?