Curious as to why you don't drill the mounting bolts while at your station? Men with big toys are fun to watch. You make my lathe look like a jewelers lathe. Great work and video.
Yes, it looks like that from afar, but once you know the job, the job becomes easier and the danger decreases. The average minimum wage is twice as much.
Kardeşim elimden geldiği kadar göstermeye çalışıyorum sabit cameram olmadığı için ancak bu şekilde çekiyorum diğer paylaştığım video larda var kanal açarken yenileri de gelecek önümüzdeki günlerde
@@hydraulicfactory а почему без спецовки? футболка, кеды. У вас там вроде не Пакистан. Для шлифовки внутренних канавок лучше бы прямошлифовалку закрепили на какой-нибудь дрын типа того, из которого сделан расточной мегарезец. Ручная подача не сильно способствует точности.
This is Turkey, brother. The channels were cut to size properly with a satin cutter. The purpose here is not to remove sawdust, but to polish the surface. That's why I use it because I have it whizzing around. We don't use a drill. What would happen if the work clothes I was wearing were satin overalls?
I use a 90,000 ton psi hydrualic to press alumina oxide ceramics into cylinders and near net shapes. That intire tube is worsthless if the internal threads seen in this video are not cut true within .001 of a inch. The most important part of the press is the threaded cap (which is not shown) that holds back all the pressure and it will fail if the ID & OD threads do not thread together perfectly, and I mean perfectly.
us so called virgins who have been doing this for more years than you've probably been alive are still here cos we didn't do any thing so fucking stupid
Thank you, band channels were opened according to H8 tolerance, and omegat nutring channels were opened to H9 tolerances. The average is between zero and ten.
@@hydraulicfactory not saying your not a good machinist, just don’t want to see anyone seriously hurt doing there job , not condemning your machinist skills there top notch
