I built better headlights for my truck using a 3d scanner and printer 

Thanks!

Thanks! 😃

Thank you! 😃

The entire assembly is printed with PETG

Thanks!

Thanks! One thing I would change is to have the LEDs closer to the exterior lens/filament, I found that they had a hard time competing with direct sunlight. Hope it works out!

Thanks! 🤣

Thank you! 😃

An led light chips please thx

I am using Ender 3's with Ender Extender Kit, Dual Z Screws, Micro Swiss NG and SKR Mini V2 E3

I updated the links in the description to what I purchased, but in a nutshell: - LM2596 drops 12v to 5v to power the LEDs - LM2596 USB drops 12v to USB to power the ESP32 - ESP32 is the brains where WLED is installed. - Logic Level Converters take the signal from the ESP32 which is 3.3v and convert it to 5v, then pass it along to the data wire on the SK6812 LED Strips Hope this helps, thanks for watching!

I was surprised how well it worked after a bit of practice! You can see better pictures on my website of what the final STL resolution was, thanks for watching!

Thank you! Depending on the application I might have to do that in the future!

Thanks! 😂