Testing out a generic import auger on the Kubota L2501. My L2501 has two mods that make it easier to run this auger that are worth noting. Keep them in mind if you're watching this and thinking about how it will perform on your L-series. I increased my rev limit to 2650 rpms (long before this), so I'm probably getting ~6.5gpm. Stock on the L2501 is a ~5.8 I believe. I also adjusted my pedal safety switch (also long before this) to allow me to 'creep' back and forth while standing. Note that I did NOT disable the seat safety. I adjusted the sensor on the pedal so that it remains thinking the pedal is in the neutral position, even if it's pressed just enough to creep forward/backward. Makes lining up for your hole a lot easier when you can see where the auger is. Auger spins at ~30rpm under load.
8 сен 2024
