How did you set up the controller to turn off the lights? I haven't had much time yet to play around and try to get them to work but I am able to get them to turn on but have not gotten them to turn off yet. I am guessing something to do with end points but I had to stop last night and won't be able to mess with them again till probably tomorrow. I do have the switch put in the correct position but also plugged in the direct battery which may be an issue also even though they don't come on till I hit ch3 for them to come on just can't turn them off after they come on. I did set one end point at 100 and the other is still at 0.
There's a little switch on the controller, out the box it's set to on. If you flip that switch it'll change to controlled on/off. I set mine to channel 3, so it's just on/off button. Channel 4 is my dig. I don't recall adjusting the end points for channel 3.
@@scalerockrc Mine is on channel 3 and all I had to do was set the end points to 100. They now turn on and off. I couldn't find any actual instructions anywhere just played with things till they came on then did the same to make them go off just took a longer than I had the first night.
I have it plugged into channel 3 on the receiver but hitting channel 3 kn transmitter like you sed still doesn't turn the lights on and off. Is there a setting on the remote I need to activate in order to make it work?
Shouldn't be, there's a switch on the light controller, you can use this light kit as constant on with direct to a battery or switched with the transmitter. It's a small switch, easily missed.