Installing Polycarbonate Greenhouse Panels Like A Pro

Подписаться 1,2 тыс.

Просмотров 72 тыс.

50% 1

Installing polycarbonate sheets is pretty simple, but there are a few basic rules that you must follow for an acceptable installation. Be sure to run your ribs vertically, be sure to allow for contraction and expansion, don't remove the protective film until you are ready to install, put the correct side toward the sun. Follow these basic requirements for a greenhouse, patio cover, conservatory that will last you for years.

Опубликовано:

11 окт 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 24

@llewellynpatrick160 2 года назад

After having watched about a dozen demonstrations (all useful but none covering the point I was looking for) I found this a very helpful collection of tips and also the answer to my question i.e. to allow 1/8" expansion for every 3' of sheet. Greatly appreciated.

@terathelos9446 5 лет назад

Simple and useful! Demonstration would be nice, but this covered most of my questions without wasting my time. Thank you!

@AdvanceGreenhouses 5 лет назад

Terat, Thank you for your kind comments. If you have any further questions I would be happy to answer them personally. Tammy

@TheTimtwnsnd 5 лет назад

A video demonstrating would be much more help

@fv1291 5 лет назад

A picture is worth a thousand words, but all I read were words, with not enough pictures to demonstrate the proper installation. Please make one showing the actual installation next time. Thank you.

@305dreamhonda 4 года назад

Thank you very helpful. I didn't get the tip about horizontal joining at gable ends?

@AdvanceGreenhouses 4 года назад

Hi, thank you for your kind comments. A lot of people will try to use two pieces of polycarbonate joined with a horizontal H on the gable ends. They have one piece that is the same height as the sidewalls and one piece on top to finish up the gable section. This should not be done. It should be one continuous piece from the ground to the top of the greenhouse everywhere. What will happen if you try to join them in this manner is you will get a leaky, moldy mess. H's should only be run vertically.

@godslittleman5451 2 года назад

Can you walk on it when it’s on the roof?

@doomsdayrats 3 года назад

What kind of presentation is this?

@lovly2cu725 2 года назад

No one knows how to make a 90 degree turn or provides a piece to join pieces together. One would think in this industry someone would have thought of that. I see greenhouses that have 90 degrees but no stupid man carries such a channel