Nice video, but please remove music on your next video. Not only is it simply not needed, I can barely hear you over the music. It's a complete distraction.
How to improve pf. I build this. When i add capacitor to supply pf goes down , why? Example, if i running a small device and its pf value is .55, when i added a 45mfd capacitor to suppy its goes down like .40 , as i searched about this, if i add capacitor pf should increase then why its decreasing.
Is the value measured in Pzem004t in seconds or minutes? Because I have 209 volts, 0.032 amps. And if that's hourly, it's almost hourly Doing 500 watts
@hrbembedded_craft thank you very much. Because I thought these values were in seconds. as I said, if they are in seconds, the values are too much. I have a question in my mind now. For example, if I want to learn these results per minute, do I need to divide all the values in the code by 60. because for example, my hair dryer says 1500 watts on the label and measured 220V- 7A on the pzemde. what should I do if I want to print this on the screen as the power consumed per minute?
Can I also use esp 32s module for this. I had a code,which was compatible with Arduino uno, now I am using esp32s and it is showing a lot of compilation errors.please help me
u have to initiate this float energy = pzem.energy(); if( !isnan(energy) ){ Serial.print("Energy: "); Serial.print(energy, 3); Serial.println("kWh"); lcd.setCursor(12,2); lcd.print(" Kwh"); lcd.setCursor(12,2); lcd.print(energy,3); } else { Serial.println("Error reading energy"); } watch the code once
