Jcb machine broken bucket piller repair work| how to repair jcb front bucket 

This was better than watching an episode of Laurel and Hardy!

the metal in the side plates was stretched out, if you cut out a small groove in the sides then heat up the bottom plate the crack in top plate would have closed up without hammering on it like you did. then weld the crack closed and put in a reinforcement plates around the hole for the pin creating a stronger repair.

You know heating metal with a torch will make bending and flatining it easier

Jesus that's rough. Might have helped them to watch an IC Weld yt video..

Abbott & Costello of the 3rd world....bigger hammer Abbott!! It's been hacked fixed before. Thanks for the laughs! You too Eddy the hack!!

Why not weld a base plate onto those metal supports so they don't fall over?

Ever hear of a pilot hole?????????

😁😁😁😁

Oh yeah, that will hold.

Yarr ye jcb nhi backhoe loader h . Jcb alag h yarr rename this but contain is good or ha algye rho best of luck

That will never hold.

Ap kahn se ho

That's not gonna fly...

Hello bro

Ну как в рашке! При помощи кувалды и какой-то матери. 🤣

Lmao 🤣

Good work 👍

Very Bad work 😂😂😂

good work

Good work

👎👎👎👎

bad work 🤦

worst repair i have seen