JHAWK Vex High Stakes Reveal/RI2D: "Fever Dream" 

Spinning claw go brrrrrr

💀

Just one?

My team had designed something similar its nice to see it works

You could end up partnered with something far worse than this. Early season this will do fine with a good driver and autons. Especially if most teams are ignoring the neutral goals.

But just in general every year I feel like I’m paired with all the mid teams and then the good ones are paired with each other

​@KenyonTess-zk3et you just gotta carry then, I beat my division's 1st seed twice while teamed with ranks 60 and lower

This was certainly inspired by some round up bots.

@@9MotorGang i can show you a video of our top 16 bot if you like. top 16 worlds

this is the whole team for that event ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-65jt0XBe2nQ.html

3dp. Not sure how accurate it is compared to the real thing but it’s at least in the ballpark.

You do you.

That's the plan

the goal was printed in 2 halves (green and white). The part where I put the super glue and they were connected was printed facing down.

@@9MotorGang ok

Yes.

I may have burnt something.

What do you mean specifically? I only have 1 ring to test with.

alot of people showed that if you have a goal upsidedown and you shake it agressively you can remove the rings. is it possible with your design?@@9MotorGang

@@9MotorGang i think if you pick up the goal and spin it fast enough the rings will come flying off of it

@@altacount990 I’ll test it out. Should have it in the explanation video.

Should have done mecanum x drive.

Drive is very clean. Chain bar is pretty good. The claw though, I resorted to my old ways.

ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-CXcmNgWCExo.htmlsi=UZfKadbd5rFAZpvO

Milk. (I’ll probably automate the claw sometime before I tear the bot down and see if that makes it any better)

About 2 inches to spare.

This is about 30 inches max height.

I tried and it can’t quite pull a Tilden.

@@9MotorGang this is unfortunate

Holding the mogos I believe

The only time it would be prone to tipping is when it is fully extended and you aren’t going to just be driving around like that. Even then it’s harder than you would think. There is such little clearance between the drive and the ground that the crossbraces act as anti tips.

@@9MotorGang ah ok smart. also my team is trying to come up with a lift. Any idea how heavy your bot is?

Read the disclaimer at the start

😳

Real robot will be dropping end of summer.