What does the ticking signal to us? When you're referring to sharpening until you hear a tick and then setting the cutter bar? Are we setting the cutter bar while running the knives/pto? Thanks for the video. Just bought a 3950, and needed to learn how to set the chopper up properly.
when setting the cutting bar the tick says the bar is touching the knives. then we back it away. but there is the slack in the adjuster so you count the turns. only do 4-5 turns on a each side at a time. you back off 9 turns to stop the tick, then turn them back in 8 turns, if don't turn the screws back in then the bar will push away from the cutter head and take a lot of power and have a hard time doing a good cut. ask away I will do my best! if I have to make a video I will.