Jura Z5 rattling sound repair.

Подписаться 3,8 тыс.

Просмотров 5 тыс.

50% 1

In this video I show you how to fix your Jura Z5 if it also makes this terrible noise. So you can enjoy a good cup of coffee again soon.
If you have any questions or comments feel free to ask. do you think it's a useful video? don't forget to leave a like.
→If you don't want to miss a video or if you want to support the channel consider subscribing.
→Instagram: / spare_time_. .
→As an Amazon Associate I earn from qualifying purchases.
Tools used:
-Torx screwdriver amzn.to/3w2sn62
-Oval head bit amzn.to/3w2sbDQ
-flat head screwdriver amzn.to/3Wbb65c
Recorded with:
-Canon 4000D amzn.to/3ZxNSt2

Опубликовано:

2 окт 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 12

@pt7628 Год назад

Thnx for the video you did a great job 👍

@unclehoss866 Месяц назад

Thank you

@VoxVeritatisOne 3 месяца назад

I found it unnecessary to open the motor casing just to disconnect the wires. For example, if you're replacing only the gear. With good lighting determine the raised areas on each spade clip. Take a small, thin, flat-bladed screwdriver and depress the tiny raised areas ('releases' if you will) then carefully wiggle and slide the spades off the terminals while holding the screwdriver in place, first taking care to make a note of the black terminal vs the red terminal for reconnection.

@StephenHolmes-kp3xx 4 месяца назад

This is a great video! Thank you! My machine is intermittently brewing coffee, and then at other times passing water right to the tray. Sometimes it makes a partial cup of coffee and just filter the rest of the water to the tray. Do you know what needs to be looked at or replaced?

@BlakeWipf 9 месяцев назад

Hello I have the same problem with one

@BlakeWipf 9 месяцев назад

I'm wondering in which position you put the brew group in to essemble everything I have a s8

@aksuli1 6 месяцев назад

I have the same problem. Brew group well fastened and cleaned, motor connection good and encoder replaced. Should I try motor or circuit board replacement?

@SpareTimeWorkshop 6 месяцев назад

If your machine makes a rattling sound at the time when normally your brewing group moves. I would rather check if the gear of the motor is not damaged. Or that the brewing group is not quite in place. I would not replace the motherboard.

@aksuli1 6 месяцев назад

@@SpareTimeWorkshop the motor looks fine. I had to cut the lowest screw from brew group and I'm using now only 2 screws, but group feels solid. Could it still be the issue?

@SpareTimeWorkshop 6 месяцев назад

@@aksuli1 It's hard for me to judge that from here. But if it makes the same sound as mine. I would check to see if your brewing group is running smoothly. Your brewing group is properly seated. Your gears are not cracked or slipping on their shaft.

@aksuli1 6 месяцев назад

@@SpareTimeWorkshop no problems in the brew group itself. It's running smoothly.