How to update Bafang motor firmware over K1 Flash.
Simple and easy, done in 30 seconds - because time is money. ;)
Included SD card with set of firmwares for M510, M500, M560, M600, M620, M820 - over 100 bin files.
Force Flash Procedure:
1. Copy just one firmware bin file into ForceFlash directory using your computer.
2. Insert SD card into K1 Flash and then power up over USB-C cable (order of these two operation matter)
3. Plug to your motor over CAN bus (5 pin green connector) - wait till blue light, then green is blinking - firmware updated, you can unplug K1 Flash
Note 1: After firmware flash, device will set configuration parameters (according AutoSet.txt config file in SD card root), just wait few seconds for steady green light.
Older versions of K1 Flash (up to v1.21) needs to re-connect CAN connector to finish settings. • K1 Flash- CAN Bafang t...
Note 2 : Your motor can refuse to flash firmware when not compatible - LED light wont be blinking red after connecting over CAN connector. Then try folder with other motor revision.
Note 3 : You can flash this way also different firmware Voltage to your motor.
More info, pictures, videos and ordering at page:
www.k1ebikes.com
Or contact us : info@k1ebikes.com
K1 Flash Light starting at 110 Eur including shipping in EU.
Warranty: 1 year , Shipping next day usually, with tracking.
K1 Flash with firmware update, including 100+ firmware bin files on SD card: 150 Eur.
Check also new K1 BB Racing - Allows to discharge battery deeper (you can set Lov Voltage Cut Off - even under 3.0 V per cell) to get more range.
- Remove power limitation at low SOC
- Set speed limit
- Over temperature safety
www.k1ebikes.c...
2 окт 2024
