Kawasaki Brute Force Wheel Bearing and Brake replacement 

I just started a complete service and inspection on my brothers '04 Honda Foreman 450. I had to replace a boot on the shaft going to the front diff. Couldn't find a RU-vid video on it but got 'er done. I figured I'd inspect the front drum brakes before I put the axles back in. I'm going to inspect the vent lines today for a blockage. Heavy surface rust on all of the brake shoe hardware and the backside of the hub on the left side. The right side components look factory new minus the brake dust on everything. The only thing I had to do on the right side was use some fine emory cloth to take the glaze off of the brake shoes.

Hi there...great video, very helpful! In the video you mentioned doing the ball joint on this BF 750 but I can't seem to find it on your channel. Did you ever do a video for it, and can you direct me to where it is? Thanks...I like your video style (not too much chatter, and you know when to cut the video on/off to reduce unnecessary time on camera) so I'm hoping you can walk me through that also. Thanks!

Nice video!

Cool vid

Unfortunately that belt box exhaust boot you added is not longer available

same thing happened to me man, i also was ridding with a passenger,, and now after 200kms on the bike the bearings go bad again ,, already have changed 2 of them.. what can cause that bearing to go bad again and again,,someone told me the hub went bad while i was riding with that bad bearing ,,and others the knuckle.. can i get an answer from you man /... thanks a lot in advance

Hi sir, is there any way I could have some help with my 2004 rm85. I’m having issues with my clutch not engaging at all. Could you please help 🙏🙏🙏

Hi sir I’m 15 I have a 1998 250 Honda recon and I need some help with replacing the rear axle bearings, if u see this plz respond i don’t know what else to do, if I can’t get it fixed my parents are going to make me sell it

Four weler Ace new video the honda rencon clush sentrifugo replasament

Hi there...great video, very helpful! In the video you mentioned doing the ball joint on this BF 750 but I can't seem to find it on your channel. Did you ever do a video for it, and can you direct me to where it is? Thanks...I like your video style (not too much chatter, and you know when to cut the video on/off to reduce unnecessary time on camera) so I'm hoping you can walk me through that also. Thanks!