KITPLANES Firewall Forward: Ignition System Basics

Подписаться 18 тыс.

Просмотров 5 тыс.

50% 1

This episode in our Firewall Forward series looks at magneto ignition systems and ignition timing. What it all means, and how to do it right. KITPLANES editor at large Paul Dye takes you through the mag-timing process from start to finish.
This series is sponsored by Tempest Aero Group - tempestaero.com/ Visit the KITPLANES website for more tips: www.kitplanes.com/firewall-fo...
#homebuiltaircraft #kitplanes #experimentalaircraft #eaa #tools #firewall-forward #aircraftengines #lycoming #continental #tempestaero

Авто/Мото

Опубликовано:

4 авг 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 11

@bobirving6052 9 месяцев назад

Great info, thanks!

@jerrygilles9612 2 года назад

Great advice for Tho's who can work on his own plane .

@briand3837 2 года назад

You mentioned the impulse coupling. I did not see where you mentioned making sure that the impulse coupling had tripped prior to setting the timing.. I haven't worked on planes is a long time but do remember addressing that point.

@KitplanesMagazine 2 года назад

Good point. It should have clicked before you come around to the timing mark, but it's worth remembering to listen for it. Thanks for the comment.

@Lerovag 2 года назад

Like always, interesting and simple thanks.

@michaelbevan3285 5 месяцев назад

any chance you could do a video on replacing ignition cables?

@n7gn 2 года назад

Thanks for the series of shows. Spark plug gasket with the curved surface up or down?

@KitplanesMagazine 2 года назад

The gaskets are flat where it counts, so either way is fine.

@n7gn 2 года назад

All recent ones I have received from ACS have a flat surface on one side and a slightly convex surface on the other surface. That is the reason for my asking the question. Help appreciated.@@KitplanesMagazine

@KitplanesMagazine 2 года назад

@@n7gn Interesting. These are usually just stamped from a sheet of copper, and the stamping makes one side have a radiused edge. I just looked at my recent handful from Spruce and they did have this edge but the faces were pretty flat. Also don't forget this is soft material and it'll deform when the spark plug is torqued. Unless they look like a bellville washer (heavily dished both sides), I would not worry about it.