Hi, I have purchased two KK 2.1.5 FC board. Both the boards are not getting connected properly and all the controls shows NO SIGNAL. CAn you kindly help me out with this.
you powering the kk board with 4 esc. it it OK? in APM pilot only 1 of the 4 esc is used. Other 3 esc do not power the board,only ground and signal is connected.
I followed your instructions and got "no yaw input". I ensured my transmitter was on before the copter. I tried factory resetting the controller. Any suggestions?
Hi hope you are doing great. I setup my quadcopter with same configuration mentioned by you. However my fourth motor is not rotating. I connect the same motor with output channel 3 then it's rotating. So in nutshell my fourth output channel is not working. Can you help me how to make any configuration for this?
Hi i followed all the instructions exactly same. But drone is not taking off. The motors are running well. But y drone isn't taking off??? Can pls someone help me with this.