KONICA MINOLTA Bizhub c252 c250 FUSER UNIT Repalcement 

fajnie że udało się pomóc !

Thank you for the comment and best regards from Poland. Części do kopiarek www.copy-expert.pl/ Facebook: facebook.com/Copy-Expert-113431678801597/ Części używane www.copy-expert.com/

:)

:)

Thank you and invite you to subscribe to my channel

You may have a problem with your HDD.

@@MrRicoh ok thk

The copier manufacturer gives the values of the counter when it is necessary to replace and gives the values of the counter when it is possible to clean. I don't know what counter you have in the copier. Check the information in the Service Manual.

Yes, this is actually the same procedure. You can model yourself on our film. Good luck. PS nice match of Mexico with Germany

yes its similar

Tak to może mieć znaczenie bo źle układa się prowadnica z separatorami i mogą się wówczas robić harmonijki. Nie zawsze ale często.

Tak to może mieć wspływ na częste zacięcia. Ja bym to wymienił. Mamy w sklepie dawcę który może się Panu przydać. Zapraszam tu: copy-expert.com/pl/p/-FUSER-Piec-KONICA-MINOLTA-Bizhub-c252-c250-2-Fusing-FUSC252/998

You probably need to replace the Fuser Unit. If you installed a new fuser unit then: Konica-Minolta bizhub C3110 Error Code: 0502 Description: Thermistor open-circuit failure The temperature detected by the thermistor/1 or thermistor/2 does not reach a predetermined level even after the lapse of a given period time after the warm-up cycle has been started. Causes: 1 Fusing unit 2 Printer control board (PRCB) 3 DC power supply (DCPU) Remedy: 1 Check the fusing unit for correct installation (whether it is secured in position). 2 Check the connector between fusing unit-PRCB CN9 for proper connection and correct as necessary. 3 Check the connector between fusing unit-DCPU CN2 for proper connection and correct as necessary. 4 Replace the fusing unit. 5 Replace PRCB. 6 Replace DCPU.

I do not know the device exactly, because it's quite an old copier.

Write something more because I don't understand the question.