This video includes- 👉 Wiring diagram of Arduino, L298N motor driver and two DC Motors 👉 Creating source code 👉 Modifications to source code to get different control methods This is the link for single DC motor control project using L298N motor driver ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-5RMwtuV7BM0.html Join our DIY facebook group for more: facebook.com/groups/projectweekend
Hi, I really appreciate your efforts and the knowledge you have shared. I am seeking help with developing a code and schematic diagram for a project that involves preset positions using push buttons, an encoder, a linear actuator, and either a DC or stepper motor, to be controlled by an Arduino Mega or UNO. The main goal is to enable the actuator to stop at specific positions selected by the user, which can be easily recalled at any time. I understand that this is quite a complicated task, but any assistance you could provide would be greatly appreciated. Regards
Thank you for your response. I believe it would be beneficial for you to initially outline each step of the task. For instance, consider factors such as how the user selects positions, the anticipated load the actuator is designed to handle, the desired level of positioning accuracy, the method for storing data, and the preferred approach for recalling saved positions. Based on these considerations, the choice of equipment, connections, and code implementation will inevitably vary. If you prefer using stepper motors, this will be helpful: ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE--K9_60j1L2Y.html
Sir how to solve the L298N overheating problem its heating like fire in 3 seconds I am making a robo car and i used four 1000 rpm 12v dc gear motor and supplying 12v then why its heating like it will explode by any moment Please reply sir please 🙏
Difference in production process. Resistences in connections or wires. Interference. Even though the speed of the motors seems the same. You should always consider rpm sensors with a control loop like a pid to correct the rom. At least for a project that requires a little precision.
Hello, i have problems with L298N i conected as in this video but the only thing that is different its that i have Arduino Nano, when i put the code on everything works the module have power and so does the arduino too, the only thing that doesnt wort its that for the OUTPUTS on motors like OUT1 to OUT4 it doesnt send power to them and the motors wont start(I use the 12V battery).
Please make sure that you connected the grounds of Arduino, Motor driver, and the battery. If still it's not working, check all your used connector wires (Jumper wires) with multimeter to make sure they are not broken inside.
