Thank you so much for the time and effort you put in to these videos ! You have saved me so much money in mechanic fees ! I am part way through overhauling my 110 . I feel like i have the best teacher in the world for free ! Thanks again !
Replacing my clutch, and I wish I would have watched this video before I ordered my replacement parts. Reason being, I would probably have ordered another release lever. I will check for any cracks before I re-install it, because after what I went through yesterday just to get down to splitting the transmission from the engine... What a mission! It feels like it would have been easier to just drive it over a cliff and buy a new one. Of course it would help if I had a proper garage with a lift etc..., instead of doing everything off of the ground. Some of these bolts were hell to get to. Oh yeah, did I say, "great video?" I do love my Land Rover and hopefully I won't have to do this again for awhile. Perhaps by then I will have a better environment in which to work on it.
I replaced my dual mass flywheel and spigot bearing now I am battling to change gears it is notchy and difficult to engage reverse gear . I suspect the spigot bush is to tight on the shaft what do you think. my clutch seems to take quite far down near the floor could this be an adjustment problem or related to gear shift? thanks for great videos they really help a lot