No video :(

Land Rover Range Rover Sport Rear Brake Replacement w/E Brake Disable How to DIY! L494 RRS

Подписаться 513

Просмотров 12 тыс.

50% 1

Installing new Rear Rotors and Pads on my 2016 Land Rover Range Rover Sport. This is a HSE Model so it has the small brakes from the factory.
Applies for all L494 Body style range rovers. Procedure to put the E Brake in maintenance Mode is in the video.
Parts purchased from Rock auto, Power Stop Pads, Centric Rotors.

Опубликовано:

5 сен 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 19

@jamescummings9305 4 дня назад

You should clean the protective film off both sides of the rotors with brake clean before putting them on.

@cpstang24 4 дня назад

@jamescummings9305 I usually spray the rotors with brake clean before I put the wheels on. Even if you do not I have yet to have a set have issues. But I agree.

@SkynetTeamDREADWING 6 дней назад

I just broke all the bolts 😢. Guide pin and that caliper bracket😢

@saifalabachi4573 Месяц назад

So helpful thank you much

@OCdaman 8 месяцев назад

What part of the video do you explain how to put it the brakes in service mode???

@cpstang24 7 месяцев назад

8 Minutes in i explain and show it.

@darwinmonsalve925 9 месяцев назад

My friend, can you help me delete the message about worn brake pads. thank you

@cpstang24 9 месяцев назад

Hi, I am wondering if perhaps your sensor is faulty or is not plugged in properly or is damaged. I never had to do a reset, I installed the new sensor, plugged it in, and when i turned the truck on the light went away.

@JakeDriventogiveFDNCorp 3 месяца назад

Is that a 2020 Range Rover sport SE I thought the rear brakes has four calipers pistons and the front brake has six caliper pistons

@cpstang24 3 месяца назад

It is a 2016. Only the SVR and 2017 HST received those brakes on the early L494. 2018+ received them as standard. The 2014-17 HSE/SE all trims received a standard brake caliper.

@davpart7723 10 месяцев назад

One question Does the suspension have to be on a certain mode to jack it up?

@crveni894 10 месяцев назад

It is recommended

@845alx6 10 месяцев назад

its easier when in off-road mode when you need to get the wheels off, as for "jacking mode" does exist but some cars go into it, and some dont. Last time i was jacking mine up i got a good 3 feet in the wheel well, and the wheels were still on the ground

@cpstang24 9 месяцев назад

As they said above it I'd recommended to be in offroad mode but I have never done it. I just jack it up at its current height and don't go any higher than necessary

@daveshore6213 5 месяцев назад

Which way does it wind in please, not sure if mine seized

@cpstang24 5 месяцев назад

Lefty loosey. But please watch more of the video I found out when I got the e brake disconnect per the trucks dash board procedure on screen it auto pushed in.

@daveshore6213 5 месяцев назад

@@cpstang24 i appreciate your reply, yes I'd watched it all the way through first, I have a clockwise piston tool, still anti clockwise on the opposite side im currently trying to do, thanks again

@cpstang24 5 месяцев назад

@daveshore6213 ok got it. If not take needle nose pliers with some pressure applied push down and twist